Kenmore Washer No Water Coming In

Pull off the two wires on the water inlet valve s terminals and unscrew the.

Kenmore washer no water coming in.

Clean up any spilled water with a towel. If it is try swapping the hot and cold hoses over on the washing machine end and check if you now only get cold water entering the machine. Unplug the washer and slide it out from the wall to leave space to access the water valves. Locate the 2 water valves one is for hot water and one is for cold water.

If the lid switch fails on these models power cannot be supplied to the water inlet valve. Unscrew the water supply lines on the back of washing machine and remove them. If both water valves are open hot and cold then there is a problem in the washer or the water supply hoses. Turn off the outlet taps and then get ready to drain the hoses into a bucket to minimize the amount of water still left in the hoses from spilling onto the floor as you unscrew the hoses from the machine.

The water inlet valve on your washing machine supplies hot and cold water for the wash and rinse. The timer or electronic control water temperature cycle selector and the water level pressure switch control the valve. Before beginning verify that you have unplugged your washing machine.